HFC-S PCI ISDN DRIVER

The default is us. Asterisk has its own set of modules that, among other things, support the various channel types. Sets the ISDN switch type, in this case to euroisdn. Sets the span number. Allows multiple channels to be treated as one for outgoing calls, in which case the first available channel will always be used. Use this command to show which Zaptel modules are currently loaded:.

Uploader: Fenrigis
Date Added: 23 October 2011
File Size: 29.15 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 92324
Price: Free* [*Free Regsitration Required]

Sets the default tonezone to specify which country’s indication tones should be used if nothing else is defined. Without any comments, the contents of the file look like this:. The installation procedures below assume that an HFC-S PCI card has already been installed and that both the operating system and Asterisk are up and running. Sets the span number. The options used here are:.

hcf-s

Billion HFC-S PCI A 2BDSO ISDN Free Driver Download (Official)

This was described in the previous article. This article describes how to configure Hf-cs 5. At this point it is safe to run a script that will both pcu load the correct Zaptel modules for the HFC-S PCI card and create a hardware configuration file. It may contain many channel definitions, although only one is included here. Here, local is used, but unknown is also sufficient. Use this command to show which Zaptel modules are currently loaded:.

For all other numbers the catch-all rule will apply and the SIP channel will be used. For outgoing calls, a choice must be made in the dial plan regarding which channel to use.

A span is a logical unit that represents a group of channels. This section is often preceded by a [trunkgroups] section that is not required here. Integrated Services Digital Hff-s. The name specified here, which is arbitrary, determines where incoming calls will enter the dial plan when they arrive on this channel definition.

Various protocols exist for CID transmission, but unfortunately some are less popular than others.

So, a variation of it to reveal more detailed information about a specific ISDN span also works:. Actually, LAP was the original data link protocol for X. The value used here is arbitrary, but must be matched in the dial plan.

For T1 connections it is the OSI layer 2 frame type: In such cases, ISDN, which is much more standardized in this respect, may be a solution. Not that this support can be described as particularly reliable, but it can certainly be regarded as adequate for most personal needs. Also called bipolar, this is a synchronous clock encoding technique in which binary 0 is represented by the absence of an electrical charge, while binary 1 the mark is alternately represented by positive and negative charges.

Although the command may be followed by specific span numbers, by default ztscan prints out information on all available spans.

Cologne Chip – HFC-S PCI A ISDN Controller IC

With digital telephony, a span usually represents a physical port on the card. Otherwise, the name of this section is arbitrary. One of them is the Zap channel module that allows Asterisk to communicate with the Zaptel device driver.

This is necessary in many countries, including the Netherlands. The first span is numbered “1” to make it the primary timing source on the system, accepting timing from the telco. Prevents national calls from being missed because the dial plan is missing a variation of the phone number associated with this channel that includes one leading zero followed by the area code.

The type of information specified here depends on the telco and the equipment hhfc-s. Once the new dial plan has been saved, isdb the changes to the running Asterisk process with this command:. Introduced inmany resellers are still marketing cards that are based on it today. This frequently complicates matters, first of all because zaphfc.